CEDAR Cambridge™ v2.5
Another significant step forward for audio restoration
Auto Dehiss™In the past, digital dehissers that used no fingerprinting or noise reduction profiling were prone to side-effects known variously as 'twittering' and 'glugging'. On earlier CEDAR processes, it was possible to avoid these unwanted sounds by careful and judicious use of the controls, but it has never been possible - until now - to remove broadband noise correctly with almost no user intervention. "The first so-called 'automatic' dehisser that works! And it really does..."Auto Dehiss embodies a more advanced algorithm than any previous dehisser. It offers significantly improved performance, and it has a unique "Auto" mode that enables the software to determine the broadband noise content, removing this without the introduction of unwanted side-effects or artefacts. Nevertheless, for users that wish to retain fine control over the noise reduction, we have retained a manual mode that allows you to control all parameters. |
|
|
Declickle 2™The original Declickle™ algorithm was superb at removing clicks and crackle, but did not 'dig' as deeply into the signal as some users wanted. So we developed Declickle 2™, which is able to detect the grungiest of low amplitude, short duration disturbances within the signal. Once detected, these can then be removed, making it possible to clean audio that would otherwise have contained low-level crackle. |
Dehiss-3™Dehiss-3™ remains available on CEDAR Cambridge™ v2.5, but at a significantly reduced (and very attractive) price. This gives owners two price/performance options when specifying the Dehiss function of their CEDAR Cambridge system. |
|
CEDAR Audio Limited
20 Home End, Fulbourn, Cambridge, CB1 5BS, UK.
Tel: +44 1223 881771 · Fax: +44 1223 881778 · Email: info@cedaraudio.com